Hello, is there a way for sending data (e.g. the up/down of a ping sensor on a switch) from prtg to scada system over modbus or opc ? Is there a documentation about it? Thanks
sending data from prtg to scada system over modbus or opc
Modified on 2025-06-10 12:33:32 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
A notification can trigger different actions, E.g.: Send an Email, execute HTTP action, execute program...
So can use a custom script to send data in different ways.
Please also take a look at the corresponding manual.
Kind regards,
Birk Guttmann, Tech Support Team
Sep, 2018 - Permalink