Solutions

Aruba IAP Virtual Controller

Modified on 2025-06-10 12:34:03 +0200

Is there a way to monitor all the APs that are linked to a Aruba Virtual Controller? I was able to do this when I had an HP MSM760 Controller but cannot seem to find a way to do so with the Virtual controllers now.

Thanks in Advance!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

Unfortunately, there is no built-in Sensor available in PRTG here, but you can configure your own custom SNMP Sensors,

Please take a look at the following KB-Post, it may help you to set this up.

Please let me know if this works fine for "Aruba IAP Virtual Controller".

Kind regards,
Birk Guttmann, Tech Support Team

Sep, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Aruba IAP Virtual Controller

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.