HTTP Push Count sensor: Display Messages Received (volume) in graph

Modified on 2025-06-10 12:35:35 +0200

Hi,

I'm using the HTTP Push Count sensor. Is it somehow possible to display the Messages Received (volume) instead of Messages Received (speed) in the graph?

Only Downtime and Messages Received (speed) is selectable as channel. The Messages Received (volume) however is displayed in the table.

Thanks in advance.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Frank,

I'm afraid the overall "logic" in all sensors is "If the value does not have a channel of its own, it does not show up in the graph".

Kind regards,

Erhard

Aug, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

HTTP Push Count sensor: Display Messages Received (volume) in graph

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.