Solutions

NetApp Fibre Channel Interfaces

Modified on 2025-06-10 12:38:09 +0200

Hi there, does anybody know if it's possible to monitor fibre channel interfaces of a NetApp? I can only monitor the ethernet interfaces with the standard sensors. I've already looked through the MIB and it seems that there is no way via SNMP for the FC interfaces?

Appreciate your feedback.

Thank you! Tobi

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Peter,

Unfortunately, we are also not aware of any way to monitor the Fibre Channels. Maybe it's worth to contact the device vendor directly as they should know if it possible or not.

Best regards.

Aug, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

NetApp Fibre Channel Interfaces

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.