How to change sensor default configuration?

Modified on 2025-06-10 12:39:07 +0200

Hi! Help me, please. How can I change snmptrafficsensor default configuration? I need "Connection Status Handling" was on 2 position not 3 for all new and old sensors.

Thank you!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Changing the default configuration of a sensor is not possible in the current version of PRTG I'm afraid. Please refer to this Knowledge Base Article to create a list of all SNMP Traffic Sensors and to edit them in bulk.

Best regards, Felix

Aug, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to change sensor default configuration?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.