Changing existing sensor from http to http advanced

Modified on 2025-06-10 12:42:35 +0200

I have about 15 HTTP sensors that I want to change to be HTTP advanced, so I can add an assertion to the response. Is it even possible? Or do I need to create them from scratch? :(

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello oralana,

Thank you very much for your contact.

I'm afraid, but you need to create the HTTP Advanced sensors from scratch. You can't change the procedure of an existing HTTP sensors to act as HTTP Advanced.

Best regards,
Sebastian

Jul, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Changing existing sensor from http to http advanced

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.