Ever since I updated both my primary and secondary Palo Alto firewalls the network traffic is showing as flatlined for both wired and wireless traffic on both firewalls. Is there a way to reset the probes? Thanks for the guidance I'm new to PRTG.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Please forward us the following information for further analysis via mail (support@paessler.com):

  • the sensor settings of both affected sensors
  • the sensor overview page of both affected sensors

Please refer to the following Ticket-ID "PAE1046038".

Best regards.


Jun, 2018 - Permalink