i have hp E2620 (10.0.9.12) and cannot receive any informaton from switch. my prtg ip 10.0.10.151 Destination Instance : 1 sflow : Enabled Datagrams Sent : 11913 Destination Address : 10.0.10.151 Receiver Port : 6343 Owner : Administrator, CLI-Owned, Instance 1 Timeout (seconds) : 2147465966 Max Datagram Size : 1400 Datagram Version Support : 5
sflow 1 sampling 1-52 500 sflow 1 polling 1-48 30 PRTG side SFLOW V5 SPECIFIC SETTINGS UDP port 6343 Sender IP 10.0.9.12
Article Comments
in fortinate firewall sflow work fine but on the switch same pronlem.. i used tester but some errow write in german language...
Jun, 2018 - Permalink
Have you paused the sFlow sensors that use the same port? Most likely the error message is about sFlow Tester not being able to bind the port. Otherwise please contact us by email (support@paessler.com) and include a screenshot of the error message.
Kind regards,
Erhard
Jun, 2018 - Permalink
Hello there,
In order to find out if proper and compatible sFlow packets are arriving at the PRTG host (or host of the Remote Probe), please use our sFlow Tester: https://www.paessler.com/tools/Sflowtester
You need to pause the sFlow sensor so that sFlow Tester can listen on the port instead. Let it run for a few minutes, then send me a screenshot of what sFlow Tester is showing to support@paessler.com, referencing this thread.
Thank you & kind regards,
Erhard
Jun, 2018 - Permalink