Solutions

SNMP Set Script

Modified on 2025-06-10 12:47:43 +0200

Hey im looking for a solution to en / disbale switchports via a snmp.

Is there a way to implement an SNMP set script in PRTG?

The script should do the following:

set 1.3.6.1.2.1.105.1.1.1.3.1.1 i 2 disable Port 1
wait x sec
disable Port 2

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

PRTG doesn't use any set commands, you'll need to use PowerShell/Batch and an EXE/Script sensor to trigger those accordingly. Using it as a notification will also work.

Kind regards,
Stephan Linke, Tech Support Team

May, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP Set Script

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.