Solutions

Automatically delete sensor by name

Modified on 2025-06-10 12:47:49 +0200

I set the "Port Name Update" field to "Automatic sensor name update if name changes in device" for my network switches. When I change a interface description on my Cisco Switches it will update the sensor name as desired. I want to know if it's possible to automatically delete the sensor if sensor's name changes to something specific like UNUSED_PORT. Maybe a script?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

PrtgApi should be able to do this :)

Kind regards,
Stephan Linke, Tech Support Team

May, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Automatically delete sensor by name

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.