Map: Status Icons\Traffic lights: specific channels?

Modified on 2025-06-10 12:48:22 +0200

Hi,

When creating a map with a Traffic Light status icon can I choose to associate that traffic light with a particular channel only, rather than the whole sensor?

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Unfortunately, that is not possible as single channels can't be up or down, only sensors have these states.

Best regards.

Apr, 2018 - Permalink

The most useful articles I found are:

May, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Map: Status Icons\Traffic lights: specific channels?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.