Solutions

Sonicwall Core 1 100% CPU SNMP

Modified on 2025-06-10 12:49:26 +0200

I cant use the PRTG. When I set SNMP in my Sonicwall to comunicate with my PRTG, all times the Core1 of my Sonicwall goes to High CPU and can report to PRTG.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Is this caused by normal SNMP polling or by sending SNMP Traps to the Core Server of PRTG?

Unfortunately, we do not have any similar issues or cases related to a SonicWall. Could you check if there is a Firmware-Update available which might fix an issue with the SNMP System?

Best regards.

May, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sonicwall Core 1 100% CPU SNMP

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.