Hi
As above - I have RMA'd some cisco ASAs.
The snmpv3 config has been recreated and show snmp user shows the users ok - the engine id has changed of course.
the Polls are dropped on the new ASA as the user isnt recognized - i think its because the ASA snmpv3 user is associated with engine id.
I cannot find any setting in PRTG to change the engine-id. Even if I delete and recreate the sensor.
Is it possible to change this value in PRTG?
Article Comments
Hey Archon,
this must be related to something else as we haven't implemented the concept of engine-ID to PRTG.
So, please double check the configured credentials for SNMPv3 and the firewall rules for the target devices.
If the issue persists afterwards, please open a new support ticket and forward us screenshots of one of the affected sensors (tabs: "Overview", "Log" and "Settings") and from the parent device (tab: "Settings") for analysis.
Best regards,
Sven
May, 2018 - Permalink
Hey Archon,
this must be related to something else as we haven't implemented the concept of engine-ID to PRTG. So, please double check the configured credentials for SNMPv3 and the firewall rules for the target devices.
If the issue persists afterwards, please open a new support ticket and forward us screenshots of one of the affected sensors (tabs: "Overview", "Log" and "Settings") and from the parent device (tab: "Settings") for analysis.
Best regards,
Sven
May, 2018 - Permalink