Solutions

Adding 3rd party SNMP Library Sensor

Modified on 2025-06-10 12:52:16 +0200

When adding sensors from 3rd party SNMP Library, some OID's are combined into 1 Sensor, whilst others get their own Sensor. These SNMP Libraries are imported using the Paesssler MIB importer.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

The sensors from the same table and kind of sensors are consolidated into one sensor. This saves you sensors, ensures a better overview (per sensor type) and allows you to easily clone these sensors.

Best regards.

Apr, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Adding 3rd party SNMP Library Sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.