I keep getting alerts from devices I have deleted
Modified on 2025-06-10 12:53:24 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I keep getting alerts over and over again on devices and sensors that have already been deleted. When I look in the PRTG log, it doesn't even show that these alerts are being sent to me. When I click on the link in the alert, I get a message that the sensor was removed. Does anyone have any clue what's going on, or how to stop this?
THanks.
Article Comments
Hi there,
Is it possible that you run an additional instance with the same (but older) configuration?
Best regards.
Apr, 2018 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
Is it possible that you run an additional instance with the same (but older) configuration?
Best regards.
Apr, 2018 - Permalink