This is our first installation. After the device discovery there is no Switch or Firewall in the root. The first item I want to test is traffic and the demo I watched used a Switch.
Why are they listed?
There are no Switches or Firewalls in our devices
Modified on 2025-06-10 12:58:28 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
In order to monitor the devices, you need to configure SNMP on the target devices. PRTG supports SNMP in the versions v1, v2c and v3. Configure a read-only community with a string of your choice. Some devices require to fill-in the PRTG Server's IP address as an agent to allow the PRTG Server to get information.
This is also described in these articles:
Please do also have a look at this short introduction video regarding monitoring via SNMP:
https://www.paessler.com/support/videos/prtg-basics/bandwidth-monitoring-basic
Apr, 2018 - Permalink