I want to be able to receive alerts if ports certain ports on a switch are set at 100Mbps
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello there,
we appreciate your contact.
This can be done with our SNMP Custom Table sensor, please have a look at this guide:
There are two OID's from two different Tables you could use, check what's available on your device:
You can deploy the sensor and use lookups or limits to alert whenever the corresponding value represents 100 mbps or less. You could also deploy the sensor once and create a device template, so that you can apply this sensor to any number of devices automatically.
Best Regards,
Luciano Lingnau [Paessler Support]
Mar, 2018 - Permalink
Hello there,
we appreciate your contact.
This can be done with our SNMP Custom Table sensor, please have a look at this guide:
There are two OID's from two different Tables you could use, check what's available on your device:
You can deploy the sensor and use lookups or limits to alert whenever the corresponding value represents 100 mbps or less. You could also deploy the sensor once and create a device template, so that you can apply this sensor to any number of devices automatically.
Best Regards,
Luciano Lingnau [Paessler Support]
Mar, 2018 - Permalink