Hi,

Since updating to version 18.1.37.12158+ I've seen a few errors pop up in our system which simply says: "potential error during bandwidth check. Loading time 0.1ms"

The sensor is green during most of the day, however I see these errors come and go. I've also noticed that all our ESXi sensors have stopped working (unsupported protocol).

I was hoping someone could point me to a list of security changes for ESXi and whether anyone has seen the bandwidth issue before as well?

Thanks!

Article Comments

Hello there,
thank you for your KB-Post.

The error message you've described is not known to me. Please share screenshots from the Overview and settings of the affected sensor.

As for PRTG's release notes for the new version, they are available here:

Best Regards,
Luciano Lingnau [Paessler Support]


Mar, 2018 - Permalink

Hi,

I keep seeing this in the overview section:

https://imgur.com/KdcczPe


Mar, 2018 - Permalink

Same issue here! "potential error during bandwidth check. Loading time 0.1ms" HTTP-Sensor. Any solutions?


Mar, 2018 - Permalink

Guys, please send us those screenshots as mentioned by Luciano and ideally create a support bundle ("Setup | Contact Support") for further investigation.

Thank you in advance & kind regards,

Erhard


Mar, 2018 - Permalink