Solutions

Upgrade failed PRTG Wont' start

Modified on 2025-06-10 13:00:55 +0200

PRTG won't start after the last update even after a server reboot

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello mtg,

Thank you very much for your contact.

Please re-run the PRTG installer from the following directory of the PRTG Core Server:
C:\Program Files (x86)\PRTG Network Monitor\prtg-installer-for-distribution\

Does it work then?

Best regards,
Sebastian

Mar, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Upgrade failed PRTG Wont' start

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.