Trying to monitor bandwidth on Meraki MX64

Modified on 2025-06-10 13:01:28 +0200

Running PRTG 18.1.38.11934. Followed the directions at https://https://helpdesk.paessler.com/en/support/solutions/articles/76000063725 and still cannot get bandwidth monitoring set up on my MX64. The custom auto-discovery shows up in there, but never get any sensors set up.

Has anyone successfully set up bandwidth monitoring on a Meraki MX64 with PRTG?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello mvalpreda,

I'd suggest to reply in the corresponding thread then.

Thank you,
Sebastian

Mar, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Trying to monitor bandwidth on Meraki MX64

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.