Solutions

Single channel graph

Modified on 2025-06-10 13:04:25 +0200

Hi all,

I'm trying PRTG and atm I'm creating the map of my sensor: graphs are a good way to show informations but usually they show every channel of my sensor how can I select which channel to show?

As example: the ping sensor show maximum, minimum, packet loss, Downtime and ping time. I only want to show downtime and ping time, how can I do this?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

I found the solution: just select, for each channel, if it has to be visibile in graph/table.

Jul, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Single channel graph

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.