Can I see the values for a built in sensor state?

Modified on 2025-06-10 13:04:55 +0200

I'm documenting our alarming system and I need to know at what threshold a Windows CPU Load will go into Warning and then Down. I have about 200 other sensors to do this with. Is there anywhere in PRTG where I can get this information?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

You can see the values either within the sensors setting tab or by clicking the small gear within the channel panel :)

Jun, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can I see the values for a built in sensor state?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.