Solutions

modify interval sensor report

Modified on 2025-06-10 13:05:34 +0200

I want to modify the warning interval scheme that sets by sensor to down. I have only now the possible choices till a maximum of 5 intervals, then set to "down"

Is this possible?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear WMostert

Only the alarm can be delayed, not the warning. This is intentional: If there is an issue, a monitoring software should show that.

Jun, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

modify interval sensor report

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.