Hello, Can someone tell me correct way to monitor the number of computers connecting to a Cisco 1140 WAP?
Monitor # of connections to a Cisco 1140 WAP
Modified on 2025-06-10 13:06:38 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The value of the current active connections should be stored in a sub OID of
1.3.6.1.4.1.9.9.273.1.1.2Use our SNMP Tester to do a walk on that OID to determine the correct OID holding the active users. Back in PRTG, use a SNMP Custom sensor to monitor that specific OID :)
Jun, 2015 - Permalink