How I can get the ip source of netflow monitor

Modified on 2025-06-10 13:08:26 +0200

I need to see the flow between sour ip and destination ip, but with netflow monitor I don't see this.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi, you can use a freeware like WireShark (packet sniffer) on your computer to see the traffic. Make a filter to the netflow port : UDP 2055. In the version 1.12.4 the filter is : udp.dstport == 2055

I hope, I answered to your question

May, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How I can get the ip source of netflow monitor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.