Can't change Settings for remote Probe
Modified on 2025-06-10 13:10:03 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
in the Enterprise console i can't change the settings "Probes Connection Ips" under Server&Probes to get Remote Probes working. The field shows "local Probe, 127.0.0.1...". The field is greayed out so i can't change this settings.
Article Comments
Hello,
You can change the connection settings for Remote Probes via the PRTG Administrator Tool on the Core Server below the Probe Settings for Core Connection tab.
Best regards
May, 2015 - Permalink
Thanks i took the wrong tool. I tried the Enterprise console instead of the admin Tools.
May, 2015 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
You can change the connection settings for Remote Probes via the PRTG Administrator Tool on the Core Server below the Probe Settings for Core Connection tab.
Best regards
May, 2015 - Permalink