Hi there,

How do I delete unwanted SNMP traps? I'm sure there's a simple way of doing it....

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

In the SNMP Trap receiver? Well, you could use the exclude filter in the sensor settings? :)


May, 2015 - Permalink

I've spent quite a while looking around the 'Messages' tab in the syslog receiver sensor but just can't see anyway of deleting traps.

I do have a few filters setup but there's often something that gets through which I'd like to delete afterwards...

Thanks!


May, 2015 - Permalink

Sorry, that's not possible I'm afraid.


May, 2015 - Permalink