Cisco CUBE SIP Trunk Monitoring and Reporting

Modified on 2025-06-10 13:10:29 +0200

Hi All,

I am trying to monitor SIP Trunks on a Cisco CUBE router using OID's provided by Cisco however when I add a customer sensor I get no such instance SNMP error #223. Can someone please assist.

Thank You

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Sorfanos

Please use the SNMP Tester to enter the device address and. SNMP string. Them please the value of the OID you want to use. Which message do you get?

If you get an error message, please perform a Walk on 1.3.6.1 (this can take awhile, the SNMP tester can become unresponsive for time) and save the log to a file. Do you find your OID in that file?

Apr, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cisco CUBE SIP Trunk Monitoring and Reporting

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.