I recently updated PRTG from v14 to v15.1.15.2022 and have now found that the device and sensor layout has changed.

Previously under v14 when you went into a device/sensor, it would have the status bar along the top, any 4/5-star priority balloons underneath that and finally the sensor-list or channel information underneath that.

After the v15 update, the status bar is still along the top, however the 4/5-star priority balloons and sensor-list/channel info (and the new similar/suggested sensor section) is side-by-side. This causes the page to be difficult to read when you have a few of the priority balloons selected.

Is this a known issue, or is there a simple fix?

Cheers!

Article Comments

Hi there,

Could you forward some screenshots to support@paessler.com to visualize the exact issue? Please refer to this Knowledge Base article.

Best regards


Apr, 2015 - Permalink