Solutions

Watchguard XTM5 series flow stats

Modified on 2025-06-10 13:12:29 +0200

I am trying to get my watchguard stats into your program. SNMP is setup and working with other devices, but all your program gives me is ping info.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Please use our SNMP Tester, run it on the PRTG Host (or host of the Remote Probe), and perform a "Scan available standard interfaces" against the target device. Which results do you get in the Tester? Please send us the result logfile from the Tester.

best regards.

Apr, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Watchguard XTM5 series flow stats

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.