Hi,

Why the altitude is set to 0? I put in 'settings' the parameters like default position (is about 200 meters). I'm using Geo Maps (reccomended) following the guide

https://helpdesk.paessler.com/en/support/solutions/articles/59647-how-can-i-track-geo-data-of-my-mobile-probe-device

Best regards

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Carlo,

Thank you for your KB-Post. This actually depends on the altitude returned by your sensor.

best regards.


Mar, 2015 - Permalink

Hi, Actually should be about 200 meters, the same of th default locationù

probe> settings >location

MtDefLoc { "id":7918, (my location id sensor) "count":200, "waypointstyle":null, "waypointmarker":2, "style":{ "strokeColor":"#0404B4", "strokeOpacity":0.7, "strokeWidth":2, "fillColor":"#0000ff", "fillOpacity":0.1 }


Mar, 2015 - Permalink

Hi,

i set my sensor right, I can see trace on the map the altitude should be 200 meter approx


Mar, 2015 - Permalink

The default location does not have an altitude setting actually, it's just 2 D. Can you please upload & share some screenshots showing the data table of the sensor with the location data, and also screenshots showing the map then?


Mar, 2015 - Permalink