SNMP-Traffic Sensor shows incorrect traffic values

Modified on 2025-06-10 13:17:50 +0200

For tests we configured a few sensors on our HP 5500 HI Switch, during the tests we transfered multiple times a 13GB large data and spotted that the SNMP-Traffic Sensor shows incorrect traffic values. The data was transfered with 114MB/s, but the sensor only shows 39-64MByte/s.

What could be the problem?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

In this case we will require more information. As such, please open a support ticket or forward us a support bundle, providing detailed information (including screenshots) as regards the issue in case.

Feb, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP-Traffic Sensor shows incorrect traffic values

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.