Hello,

I contact you because i have an issue with the PRTG.

I added the SNMP Custom sensor to monitor Firewall Concurrent Connections of our one of the Checkpoint Firewall with below OID OID: 1.3.6.1.4.1.2620.1.1.25.3.0

I am getting an error message as "No such object (SNMP Error #222)" for this SNMP Custom sensors and all other sensors are green and running.

But for other Checkpoint Firewalls I am getting good value with Same OID for Firewall Concurrent Connections.

Thank you for helping me.

Article Comments

Hi,

test the OID with the snmp-Tester from here. If you get a result something "on the way" may be wrong. If you get no result, and other snmp sensors on your device will work, there is no such value on this machine. Try a walk with the Tester to find the correct OIDs.

hth Martin


Feb, 2015 - Permalink

Hello Martin,

Thanks for your prompt response. I tried with SNMP tester, but getting same error :( All other sensors are for that Checkpoint firewall is working correctly with good value. Please suggest.


Feb, 2015 - Permalink

Hi,

did you take a walk with the snmp tester? try a walk from 1.3.6.1.4.1.2620.1.1.25 and take a look at the results. if there is no oid, the firewall dont deliver the values. Check the snmp configof these firewall, is it the same as the other ones? Is the general config of the firewall different? maybe you can post the walk?

hth Martin


Feb, 2015 - Permalink