My SNMP Credentials is ok. I also managed to set up SNMP Traffic to my switch, but when it regards to SNMP CPU Load it's says "No Such Name (SNMP error # 2)"

I also try the SNMP Tester and it works fine but when I try to add the SNMP CPU Load sensor again the error still appearing

Article Comments

I've observed a similar issue with the same sensor (SNMP CPU Load) falling into error state with "No Such Name (SNMP error #2)", but usually healing to OK after some time. Didn't find out yet what the problem is, maybe the sensor is somewhat unstable.


Feb, 2015 - Permalink

Could you please use the SNMP Tester and perform a walk with the OID

1.3.6.1.2.1.25.3.3.1.2

against the target device when the sensor reports the No such name error again?


Feb, 2015 - Permalink

It says Value: Generic Error (SNMP error # 5)


Feb, 2015 - Permalink

I'm sorry the last one I sent was wrong, still Value: No Such Name (SNMP error # 2)


Feb, 2015 - Permalink

here for your reference http://postimg.org/image/ftv6telix/


Feb, 2015 - Permalink

Hi,
please check with the vendor of the switch if the device is delivering CPU data at all. As from what I can see from the tester results and error messages in PRTG, this might not be the case.
Please check also with the vendor if they are possibly offering a MIB file which can be used to access these information.
Best regards


Feb, 2015 - Permalink

Ok thanks


Feb, 2015 - Permalink