Solutions

Reporting

Modified on 2025-06-10 13:19:07 +0200

Is there a stats in reporting that says "auto acknowledge"? It seems that if you acknowledge a sensor it will go to "down stats" Is there a way to sever the data?

Uptime Stats: Up: 0 % [0s] Down: 100 % [8h2m0s] Request Stats: Good: 0 % [0] Failed: 100 % [484]

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Dan Paolo

Thank you for using PRTG. I am sorry, it is not possible to report the "auto acknowledge" time.

Please let me know if you have further questions.

Feb, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Reporting

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.