Adding Load Balance device for Bandwidth check

Modified on 2025-06-10 13:20:13 +0200

Hi All...

We are using RADWARE Load Ba-lancer, And please help me to add the same device for bandwidth checking...

Thanks & Regards, Srinivas. N

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear srinivas

Thank you for using PRTG. If your load balancer supports SNMP, please add it as device, enter the SNMP credentials in the device settings and add SNMP Traffic sensors.

Jan, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Adding Load Balance device for Bandwidth check

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.