Does PRTG automatically choose what specific sensors suits your network?

Modified on 2025-06-10 13:20:16 +0200

After setup, when we choose automatic discovery, the system already choose what sensors it will activate per machines. Is this automatic each setup?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Thank you for using PRTG. Yes, this is indeed done automatically. You can configure the Auto-Discovery (which is the process behind the automatic detection of devices & sensors) as well though.

best regards.

Jan, 2015 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Does PRTG automatically choose what specific sensors suits your network?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.