Is there an easy way to set up the scanning interval at the sensor type? For example, I would like to check CPU utilization every 60 seconds and check disk usage every 30 minutes. Rather than going through every device and setting the intervals for each sensor, I'd rather change it at a top level sensor type and have it apply to all devices.
Multiple scanning intervals
Modified on 2025-06-10 13:21:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The easiest way is: Choose on the top Sensors -> by Type -> choose your Sensor type (for example Windows CPU Load) All your Windows CPU Load Sensors will be shown now. Click select all and then click on settings (at the top on the right) Now you can change some settings for all of these Sensors like the interval.
Regards Birk Guttmann
Jan, 2015 - Permalink