Monitor SOAP-Interface
Modified on 2025-06-10 13:28:25 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Good Morning
Is it possible to monitor a SOAP-Interface?
We are interested to monitor our interfaces, if they are running. We have a function in the Interface to monitor this case, but how can we connect with PRTG to this interface?
Thank you
Remo St.
Article Comments
How are you currently monitoring the SOAP Interface? What you may need to look into would be building a custom sensor that would be able to read the output of your SOAP requests and then format it so that PRTG is able to read the results. More information about how this can be done can be found under Setup->PRTG API -> Custom Sensors.
Dec, 2014 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
How are you currently monitoring the SOAP Interface? What you may need to look into would be building a custom sensor that would be able to read the output of your SOAP requests and then format it so that PRTG is able to read the results. More information about how this can be done can be found under Setup->PRTG API -> Custom Sensors.
Dec, 2014 - Permalink