Solutions

brocade switches support

Modified on 2025-06-10 13:28:51 +0200

Hello

I wanted to know does PRTG support brocade switches similar to cisco switches ? Can we do auto-discovery for interfaces on brocade as well ?

Regards, Amar

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

The OID's that are used for network device interfaces do not change between manufacturers and we have designed our Interface sensors to use these generic OIDs, so you should be able to add the interfaces from just about any network device and have them work properly.

Dec, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

brocade switches support

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.