Modified on 2025-06-10 13:29:18 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
When i try to get the SNMP sensor to work i keep getting (SNMP error # -2003), I have tried diffrent SNMP versions but i get the same problem all the time. Hopfully someone can help me out here or point me in the right direction!
With kind regards,
Dave Nienhuis The Netherlands
Hey Dave,
there is the same question on october 2010 with an good idee to deal with.
You can try to figure out the problem with the paessler snmp tester. It is a Windows-Software what can be installed on the same host, and on other systems. With this software you be able to check the snmp requests.
I refer to this article: https://https://helpdesk.paessler.com/en/support/solutions/articles/76000063697
If this won't help you, try this one, debugging and fixing snmp problems with and via PRTG: https://helpdesk.paessler.com/en/support/solutions/articles/76000041708-my-snmp-sensors-dont-work-what-can-i-do
Best
Sascha
Dec, 2014 - Permalink