Solutions

juniper monitor

Modified on 2025-06-10 13:29:24 +0200

After I run auto discover for my juniper firewall, seems only configured interface are shown. I would like to know is it normal? And any way can add all interfaces?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Jimmy,

The auto-discovery adds traffic sensors for interfaces which haven't been added before and where the traffic is not null. If you want to add additional interfaces, you can add an SNMP Traffic Sensor and choose the interfaces manually.

Best regards

Dec, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

juniper monitor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.