how to monitor juniper EX4200 virtual chassis

Modified on 2025-06-10 13:29:26 +0200

I have imported juniper's mib to prtg, our system have juniper EX4200 and EX2200. EX2200 can auto discover many sensors. But EX4200 seems only HTTP sensor are working, EX4200 surely enabled SNMP, any further configure is needed? Thank!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Jimmy,

After converting the MIB file to an OIDlib you'll need to add an SNMP Library Sensor to your device and choose the values of your interest.

Best regards

Dec, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

how to monitor juniper EX4200 virtual chassis

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.