After i moved PRTG to a different machine, everything works fine except for lookups. They are not being created when i use MIBs for differnt sensors. Is there a way to point it a folder where lookups should be. The installation folder on old PC was on Drive C:\, now it's drive D:\.
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
The lookup folder cannot be in any other location, than the PRTG Program files folder. So this has to be correct, as its hard-coded. The MIBs you are using, were they imported with the latest version of the MIB-Importer?
best regards.
Nov, 2014 - Permalink
I used Paessler MIB Importer V3.4.8 alpha. It was working fine before i moved it to a new PC. Same version of MIB importer.
Nov, 2014 - Permalink
What happens if you try re-adding the sensors? Also, do you still have access to the old PC, to migrate the lookup files?
Nov, 2014 - Permalink
I re-added sensors. Nothing was created at lookups. I migrated all lookup files the first time I did it. The problem is not with existing files, it's with the new ones that im creating. New sensors don't create lookup files like it was before.
Nov, 2014 - Permalink
Do they use existing Lookups by any chance? Please upload some screenshots showing these sensors and their channel settings.
Nov, 2014 - Permalink
any ideas? please help.
Nov, 2014 - Permalink