I am trying to setup monitoring of our BCM 450 PBX. It is running Linux OS. The Auto discovery found ping, http, IMAP and 2 LANs. When I try and add a sensor for CPU usage (or anything else) using v1 SNMP it gives an error saying "No Such Name (SNMP error # 2)" I have made certain that the PRTG server ip-address is allowed to connect to BCM and have made sure that the Community strings on PRTG server and BCM are the same. I have tried using v1 and v2c SNMP versions, but get the same error message. I have done an SNMPWalk fron the PRTG server and I see OIDs returned.
Problem setting up SNMP for monitoring a BCM 450
Modified on 2025-06-10 13:31:09 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Please use the SNMP Tester on the Probe Device and do an SNMP walk on the OID 1.3.6.1 Please forward the zipped results to support@paessler.com and refer to this knowledge base article.
Best regards
Nov, 2014 - Permalink