Question on the netflow sampling rate, we have our nexxus core switch doing netflow off an interface. The sampling rate configured in the switch is 1 to 100.

So when I set up the netflow receiver in PRTG I say yes its a sampled netflow, but what do I put in there for the value, since it 1% of the traffic do I put on in there 1 or since netflow is sampled at 1 to N, do I put N in there for the value, 100 in my case.

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Kube

Please enter 100 for the 1/100 (1%) sampling rate.


Nov, 2014 - Permalink