I am using open PRTG for snmp Traffic monitoring . but i always get the error

" No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003)"

I am trying to monitor LAN PC for SNMP traffic. but failed. Windows SNMP setting is set to community. firewall is disabled. but same issue appears.

> Need guidance as i am a beginner. prtg,snmp,wmi

Article Comments

Hello,

Please follow this guide to troubleshoot your SNMP 2003 error. Please do also make sure that your PRTG Server is listed on the "Allowed Hosts" in the security tab of your SNMP service settings. After you checked all the steps of this guide use the SNMP Tester and scan the device for e.g. the uptime. Do you get any values using the tester?

Best regards


Oct, 2014 - Permalink

By Using SNMP tester getting ERROR

Value: Error converting OID (SNMP error # -2007)

where do i found OID


Nov, 2014 - Permalink

Same Issue is reported With SNMP tester

Value: No response (check: firewalls, routing, snmp settings of device, IPs, SNMP version, community, passwords etc) (SNMP error # -2003)


Nov, 2014 - Permalink

Hello,

Please forward a screenshot of your SNMP settings you configured for the Windows service to support@paessler.com and refer to this knowledge base article.

Best regards


Nov, 2014 - Permalink