Solutions

ASA 9.1(3) and Netflow

Modified on 2025-06-10 13:32:41 +0200

Hi!

I see earlier questions about Netflow from ASAs not getting through to PRTG Netflow 9 124sensor.

I am running a demo of PRTG, evaluating if this is a tool for us, and I get the flows (and templates) if I check using Netflow tester.

However, I get no data into the sensor on PRTG.

I run ASA software 9.1(3) and PRTG 14.4.12.3283.

Any suggestions?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Rockbear

Please contact support@paessler.com and include a screenshot of the Netflow tester as well as of the settings page of the Netflow sensor. Please send multiple screenshots if necessary to cover all settings of the sensor.

Oct, 2014 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

ASA 9.1(3) and Netflow

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.