I notice that for down sensors the Subject line format is correct showing the site, device, sensor, and status. When I get the corisponding sensor UP message or a status summary message the subject line is preceeded with the phrase "PRTG Network Monitor" which obscures the rest of the important information in the Subject line. How can I remove this so that my UP, down, and Summary notifications are all in the same format for the Subject line?
How can I change Subject line in Noifications
Modified on 2025-06-10 13:32:50 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
You should be able to change the subject for the summary emails under the Notification Settings -> Subject for Summarized Messages.
Oct, 2014 - Permalink