Hi, I would like to monitor the throughput of network adapters teamed using the HP teaming software, but the "virtual" adapters do not show in the available adapter list. How do I do this?

Article Comments

What precise sensor type are you using (WMI, SNMP)?

If the adapters are not showing up automatically, it is highly likely PRTG cannot discern the same at the moment.


May, 2012 - Permalink

Hi.

I have same question, I would like to monitor 3 "virtual" interfaces on HP Proliant, which were created with HP Teaming config tool. When I add Network SNMP Sensor, I can choose all three interfaces, but I get same result for all three, even if I choose different interfaces.

Regards, Luka


Oct, 2014 - Permalink